Heavy Conveyor Belts 6mm to 12mm thickness and available in One Meter Length.
1.MS Bolt Hinge Type Two Pcs Fastener with Bolts & Nuts and One Hinge wire All Zinc Galavanized (1 meter Length each) 1000mm to 2000mm long
Features:
» installed by Bolts and Nuts directly
» Belt is clamped by the fastener itself
» Rubber belts can be repaired and back to workimmediately
» Can be installed closer to the carcass after rubber covers are skived off
» Turn fastener upside down for a more leakproof and longlife
» Ease of installation
» Perforated for ease of separation for troughing
» Friendly for the belt with less penetration points
» May install the pin prior to the fastener installation
» Good compression.
Belt fasteners MS 45 & 65 Screw Type with Screws suitable for Conveyor Belts 6mm to 12mm & 12 mm to 20mm thickness available in 1000mm (One meter long) to 2000 mm long
1.MS 45 & 65 Screw Type (Two Pcs Fastener with Screws and One Hinge Pin All Zinc Galavanized
Features:
1. Does not required any special lacing tool for making a lacing joint.
2. Suitable for Higher Belt ratings.
3. Offered is Metallic clips & Tie Rod. This works on super screws well seated in the clips rubber covers when fightened.
4. Available for M-24, HR & SHR belts.
5. Much lasser time and skill required to make a lacing joint.
